FAQ for Door Hinge Repair
Q: What's the removal procedure for the rear sliding door lock striker?
A:
The removal procedure is to remove the right-hand body side trim panel, the two bolts that retain the rear storage compartment if equipped, the bolts, the striker, the spacer, the washer, and the nut plate.
By BobGM Specialist
02/11/2022 Q: What's the installation procedure for the rear sliding door lock striker?
A:
The installation procedure is to install the nut plate, the washer, the spacer, the striker, and the striker bolts, then tighten the striker bolts to 24 N.m (18 lb-ft), and install the right-hand body side trim panel.
By BobGM Specialist
02/11/2022 Q: What should be done before removing the rear door hinge (Cargo Doors)?
A:
You will need to remove the door from the vehicle.
By BobGM Specialist
01/11/2022 Q: What should be noticed when you drill a 13.0 mm (1/2 in) hole through the hinge base?
A:
You must not drill through the door or the body pillar.
By BobGM Specialist
01/11/2022 Q: How to adjust the door to fit properly in the door opening frame?
A:
You will need to ensure that the left door is closed when adjusting the right door, but do not close the right door completely until a visual check is made in order to determine that the lock assembly is properly engaged to the striker.
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the bolts hinge to the door?
A:
The recommended torque is 27 N.m (20 lb-ft).
By BobGM Specialist
01/11/2022 Q: What's the recommended torque for the bolts installed on the door and the body frame?
A:
The recommended torque is 27 N.m (20 lb-ft).
By BobGM Specialist
01/11/2022 Q: What's the removal procedure for the door striker?
A:
The removal procedure is to remove the interior trim if necessary to gain access to the striker nut, remove the door striker using J 29843-9, hold the nut to prevent the nut from falling into the body pillar, remove the nut, the spacer, and the insulator, then adjust the striker to properly engage the door lock once the door is adjusted within the frame, ensure that the striker is used to adjust the door for flushness only, not to raise or lower the door.
By BobGM Specialist
29/10/2022 Q: What's the removal procedure for the left rear door striker?
A:
The removal procedure is to remove the trim panel, separate the water deflector at the perforations, then remove the nuts from the striker, and finally remove the insulator and the striker.
By BobGM Specialist
29/10/2022 Q: What's the removal procedure for the rear door latch striker?
A:
The removal procedure is to remove the bolts that retain the striker, then remove the striker from the vehicle.
By BobGM Specialist
29/10/2022 See more FAQs (8)