Part Description: 2000 GMC C3500 Module, Knock Sensor
More Info
Vehicle Fitment
2000 GMC C3500 | Sierra SL, Sierra SLE, Sierra SLT | 8 Cyl 5.7 L CNG, 8 Cyl 5.7 L GAS
FAQ for Ignition Coil Repair
Q: How do I install the ignition coil?
A:
You should install the ignition coil, the ignition coil, the bracket, the ignition coil wire, the electrical connectors, the air cleaner assembly, and the nut.
By Bob
GM Specialist
01/11/2022
Q: How do I remove the ignition coil?
A:
You should remove the air cleaner assembly and nut and disconnect the electrical connectors, remove the ignition coil wire to the distributor, remove the studs holding the bracket and the ignition coil to the intake manifold, remove the bracket and the ignition coil, drill and punch out the two rivets holding the ignition coil to the bracket and remove the ignition coil from the bracket.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How do I remove the knock sensor?
A:
You should disconnect the negative battery cable, raise the vehicle, and remove the Knock Sensor harness connector and the knock sensor.
Q: What should be cautioned about the diode?
A:
If the diode is located next to a connector terminal remove the terminal(s) from the connector to prevent damage from the soldering tool, you can remove the inoperative diode from the harness with a suitable soldering tool.
Q: How do I install the ignition control module?
A:
You should install the ignition coil to the bracket with the two screws, install the ignition coil and the bracket to the intake manifold with studs, and install the ignition coil wire, the electrical connectors, the air cleaner assembly and the nut.