Notes: with Automatic Rear Air Leveling System;without Automatic Rear Air Leveling System;For Towing & Hauling;AK29 Adapter Kit is Reqd to Install this Unit when Adapting Air Adjustable Shock Absorbers to Vehicles w/o Rear Air Leveling System
Compressed Bumper Stop: Yes
Compressed Length: 12.75"
Dust Shield: Yes
Dust Shield Material: Rubber
Extended Bumper Stop: Yes
Extended Hydraulic Lockout: No
Extended Length: 20.125"
Lower Mounting: Loop Bushing and Sleeve Mount - 0.48" Sleeve ID x 1.5" Sleeve OAL
Stroke Length: 7.375"
UPC: 048598031877
Upper Mounting: Loop Bushing and Sleeve Mount - 0.48"- Sleeve ID x 1.5"- Sleeve OAL
Part Description: 2000 Chevrolet Venture Max-Air™ Load Adjusting Rear Shock Absorbers
Notes: FULLY ASSEMBLED - READY TO INSTALL;Excludes Rear Air Leveling System & AWD
UPC: 815716028152
Part Description: 2000 Chevrolet Venture Front and Rear Suspension Strut and Coil Spring Assembly Shock Absorber Set
More Info
Vehicle Fitment
2000 Chevrolet Venture | All Trims | 6 Cyl 3.4L
2000 Chevrolet Venture | All Trims | All Engines
FAQ for Shock Absorber Repair
Q: How to remove the Shock Absorber?
A:
You should support the rear axle and disconnect the air tube connector. In addition, you should remove the shock absorber bolt and the shock absorber.
By Bob
GM Specialist
01/11/2022
Q: What is the recommended torque for the shock absorber bolts and nuts?
A:
The recommended torque is 85 Nm (63 ft. lbs.).
By Bob
GM Specialist
01/11/2022
Q: How to install the Shock Absorber?
A:
You should install the shock absorber, the shock absorber bolts, and the air tube connector. In addition, you should remove the support from the rear axle.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to remove the Steering Knuckle?
A:
First, you should remove the tire, the brake caliper bracket, the brake rotor, and the front wheel bearing/hub. Next, you should disconnect the lower control arm ball stud and the outer tie rod. Finally, the Steering Knuckle should be removed.
Q: How to remove the wheel cylinder?
A:
You should remove the tire, the brake drum, the brake pipe nut, and the Wheel Cylinder. In addition, you should clean the old sealant from the backing plate where the wheel cylinder was installed.
Q: How to install the vacuum brake booster hose?
A:
You should connect the vacuum hose to the intake manifold and the vacuum Brake Booster.