2000 Chevrolet Tracker Fuel Injector

The procedure is to set the rotary dial of the DMM to the V (DC) position, connect the positive lead of the DMM to one end of the circuit to be tested, connect the negative lead of the DMM to a good ground, and then turn ON the ignition and operate all accessories. It should be noticed that if the voltage measured is greater than 1 volt, there is a short voltage in the circuit.

The procedure is to remove the throttle body, remove the hold-down bracket at the rear of the intake manifold, remove the hold-down bracket bolts from the intake manifold, remove the hold-down bracket bolt for the fuel pipes, and then remove the fuel injectors.

The proper way is to install the fuel injector to the fuel rail, install the fuel rail to the intake manifold, install the 3 retaining bolts, install the intake manifold reinforcement bracket, and then install the scan tool.