Part Description: 2000 Chevrolet Tracker Bolt-Bracket Differential Front Mounting(M12X1.25X85)(No Sub)
More Info
Vehicle Fitment
2000 Chevrolet Tracker | Base, LSi, LT, ZR2 | 4 Cyl 1.6 L GAS, 4 Cyl 2.0 L GAS, 6 Cyl 2.5 L GAS
FAQ for Camber and Alignment Kit Repair
Q: What is the procedure for the turning angle adjustment?
A:
The procedure is to loosen the steering gear boot outer clamp, measure the length of the right inner tie rod and the right outer tie rod, measure the length of the left inner tie rod and the left outer tie rod, compare the two lengths, adjust the toe, tighten the tie rod end lock nuts, ensure the steering gear boots are not twisted, and then tighten the steering gear boot outer clamp.
By Bob
GM Specialist
01/11/2022
Q: What is the procedure for the front caster and camber adjustment?
A:
The procedure is to measure the wheel alignment, compare the vehicle alignment with the specifications, inspect the suspension components, replace any components that display the above conditions, and then inspect the body for conditions that may cause the caster and the camber to be out of specification.
By Bob
GM Specialist
01/11/2022
Q: What is the procedure for the front wheel toe adjustment?
A:
The procedure is to loosen the lock nuts, loosen the steering gear boot outer clamp on the inner tie rod, rotate the left tie rod and the right tie rod by the same amount, rotate the left tie rod and the right tie rod, ensure the steering gear boots are not twisted, and then tighten the steering gear boot outer clamp on the inner tie rod.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: How to install the wheel cylinder?
A:
The proper way is to install the gasket to the Wheel Cylinder, install the wheel cylinder to the backing plate, install the brake shoes, install the brake drum, and then install the rear tire and wheel assembly.
Q: What is the proper way to install the brake drum?
A:
The proper way is to install the Brake Drum, install the locking washers to the wheel studs, install the tire and wheel assembly, and then install the console.
Q: What is the proper way to install the hydraulic hose?
A:
The proper way is to install the Hydraulic Hose, install the flare nuts with the 2 wrenches, install the E-clip that joins the hoses and the pipes, and then bleed the system.