Part Description: 2000 Chevrolet Monte Carlo Vehicle Speed Sensor
More Info
Vehicle Fitment
2000 Chevrolet Monte Carlo | LS, LS Competition, LS Sport, LT, LTZ, SS, SS 35th Anniversary Edition, SS Dale Earnhardt Signature Edition, SS High Sport, SS Pace Car | 6 Cyl 3.4 L GAS, 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 5.3 L GAS
Part Description: 2000 Chevrolet Monte Carlo Vehicle Speed Sensor
More Info
Vehicle Fitment
2000 Chevrolet Monte Carlo | All Trims | 6 Cyl 3.8L
2000 Chevrolet Monte Carlo | All Trims | 6 Cyl 3.4L
$14.32
FAQ for Vehicle Speed Sensors Repair
Q: What is the removal procedure for the transmission speed sensor?
A:
The procedure is to remove the case side cover, disconnect the transaxle wiring harness, remove the input speed sensor clip, remove the input speed sensor and inspect the input speed sensor.
By Bob
GM Specialist
01/11/2022
Q: How do you install the vehicle speed sensor?
A:
You can install the O-ring, the vehicle speed sensor, the vehicle speed sensor bolt, the vehicle speed sensor wiring harness connector, and the right front tire and wheel assembly and lower the vehicle.
By Bob
GM Specialist
01/11/2022
Q: How do you install the transmission speed sensor?
A:
You can install the input speed sensor, install the input speed sensor clip, connect the transaxle wiring harness and install the case side cover.
By Bob
GM Specialist
01/11/2022
Q: What is the removal procedure for the vehicle speed sensor?
A:
The procedure is to raise the vehicle and remove the right front tire and wheel assembly, the vehicle speed sensor wiring harness connector, the vehicle speed sensor bolt, the vehicle speed sensor, and the O-ring.
By Bob
GM Specialist
01/11/2022
FAQ for Other Repair Info
Q: What is the proper way to install the fluid filter?
A:
You can install a new seal, install the filter and install the gasket and the oil pan.
Q: What is the recommended torque when installing the transaxle oil cooler pipe clip bolt?
A:
You can tighten the transaxle oil cooler pipe clip bolt to 4 Nm (27-inch lbs.).
Q: What can you use to push the metal end fitting of the shift control cable and the transaxle cable end together?