2000 Chevrolet Monte Carlo Steering Knuckle

You can install the rear suspension knuckle, hand start the rear suspension strut to knuckle bolts, connect the rear wheel spindle rods and the rear suspension trailing arm to the knuckle, install the rear wheel hub, connect the ABS electrical connector, install the brake caliper and bracket, install the brake rotor, install the tire and wheel assembly, lower the vehicle and adjust the rear wheel alignment.

The procedure is to raise the vehicle, remove the tire and wheel assembly, remove the front wheel drive shaft bearing, remove the front lower control arm ball stud-to-knuckle cotter pin and nut, separate the front lower control arm stud from the front steering knuckle, remove the outer tie rod end, scribe the strut to the knuckle, remove the bolts and remove the knuckle.

The procedure is to raise the vehicle, remove the tire and wheel assembly, disconnect the ABS electrical connector, remove the brake caliper and bracket, remove the rotor and the rear wheel hub, disconnect the rear wheel spindle rods and the trailing arm from the knuckle, remove the rear suspension strut to knuckle bolts and remove the rear suspension knuckle.

You can install the knuckle, the bolts, and the outer tie rod, connect the front lower control arm ball stud to the knuckle, install the front lower control arm ball stud nut, install the front lower control arm ball stud cotter pin, install the front wheel drive shaft bearing, install the tire and wheel assembly and lower the vehicle.