Part Description: 2000 Chevrolet K3500 Motor, Rear Window Wiper
More Info
Vehicle Fitment
2000 Chevrolet K3500 | Base, Cheyenne, LS, Scottsdale, Silverado | 8 Cyl 5.7 L GAS, 8 Cyl 6.2 L DIESEL, 8 Cyl 6.5 L DIESEL, 8 Cyl 7.4 L GAS
FAQ for Windshield Wiper Motors Repair
Q: How to remove the rear wiper motor?
A:
You shall remove the wiper arm, four retainers from the wiper motor cover, the cover from the wiper motor, the spacer and the washer from the wiper motor drive shaft, and the wiper motor from the vehicle.
By Bob
GM Specialist
01/11/2022
Q: How to install the wiper motor?
A:
You need to install the wiper motor, the three bolts, the drive link brackets to the wiper motor crank arm, the air inlet grille panel, and the wiper arms.
By Bob
GM Specialist
01/11/2022
Q: How to install the rear wiper motor?
A:
You need to install the wiper motor, the washer, the spacer, the nut in the liftglass, the bolt to the wiper motor, the cover, four retainers in the cover, and the wiper arm.
By Bob
GM Specialist
01/11/2022
Q: How to install the wiper motor module?
A:
You need to install the module in the wiper motor, and the wiper motor cover and connect the electrical connector to the wiper motor.
By Bob
GM Specialist
01/11/2022
Q: How to remove the wiper motor?
A:
You shall remove the wiper arms and the air inlet grille panel, the brackets from the wiper motor crank arm, and the three bolts and the wiper motor from the vehicle.
By Bob
GM Specialist
01/11/2022
Q: How to remove the wiper motor module?
A:
You shall disconnect the electrical connector from the wiper motor, and remove the three screws, the wiper motor cover, and the module from the wiper motor.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: How to install the windshield washer pump?
A:
The proper way is to install the Washer Pump(s) in the washer solvent container, and the washer solvent container on the vehicle.
Q: How to remove the wiper arm blade?
A:
You shall turn the ignition switch to the ACCY position, set the wiper switch to the PULSE position, turn the ignition off, push in the button of the Wiper Blade clip, remove the wiper blade, and bring the wiper arm out through the opening.
Q: How to remove the windshield washer reservoir?
A:
You shall remove the auxiliary battery and battery tray, disconnect the hose(s) from the washer pump(s), and the electrical connector(s) from the washer pump(s), and remove the washer solvent container from the vehicle.