Notes: with OE # 16216588;Vehicle specific Flash programming req'd ON or OFF the vehicle.Accurate VIN & mileage are req'd. Additional vehicle specific on-car programming must be performed AFTER installation to prevent drivability & starting issues.
Notes: Knock Module must be removed from original PCM and installed in replacement PCM;Vehicle specific Flash programming req'd ON or OFF the vehicle.Accurate VIN & mileage are req'd. Additional vehicle specific on-car programming must be performed AFTER installation to prevent drivability & starting issues.
Notes: 1996-00, W/O Diesel; All Models; 5.7l, 7.4l
Other Names: ECM, PCM
Item Dimensions: 10.8 x 8.2 x 4.1 inches
Item Weight: 5.60 Pounds
Fitment Type: Direct Replacement
Part Description: 2000 Chevrolet K3500 PCM
More Info
Vehicle Fitment
2000 Chevrolet K3500 | Base, LS | 8 Cyl 5.7 L GAS, 8 Cyl 7.4 L GAS
FAQ for Engine Control Module Repair
Q: How to remove the vehicle control module(VCM)?
A:
The proper way is to remove the VCM retainer clip, the VCM from the VCM bracket, the VCM harness connectors, the knock sensor module access cover screws, the knock sensor module access cover, and the knock sensor module.
By Bob
GM Specialist
01/11/2022
Q: What should you do if the VCM fails to program?
A:
The proper way is to check all the VCM connections, and the ITCS terminal and equipment for the latest software version, and try again to program the VCM. If the programming fails again, you shall replace the VCM.
By Bob
GM Specialist
01/11/2022
Q: How to set up for programming the VCM electrically erasable programmable read-only memory (EEPROM)?
A:
You shall fully charge the battery, turn the ignition is ON, and secure the scan tool connected to the Data Link Connector (DLC).
By Bob
GM Specialist
01/11/2022
Q: What should be learned about when servicing with splicing inline harness diodes?
A:
If the diode is located next to a connector terminal, you shall remove the terminal(s) from the connector to prevent damage from the soldering tool.
By Bob
GM Specialist
01/11/2022
Q: How to install the vehicle control module(VCM)?
A:
You shall install the knock sensor module, the knock sensor module access cover, the VCM into the VCM bracket, and the VCM retainer clip.
By Bob
GM Specialist
01/11/2022
Q: What should be noticed when servicing with splicing inline harness diodes?
A:
To prevent shorts to ground and water intrusion, you shall completely cover all exposed wire and diode attachment points with tape.
By Bob
GM Specialist
01/11/2022
See more FAQs (1)
FAQ for Other Repair Info
Q: How to install the ignition coil and ignition control module (ICM)(HVS)?
A:
The proper way is to install the Ignition Coil to the bracket, the ignition coil and the bracket to the intake manifold, the ignition coil wire, the electrical connectors, and the air cleaner assembly.
Q: How to remove the knock sensor?
A:
You shall disconnect the negative battery cable, and remove the Knock Sensor harness connector, and the knock sensor from the cylinder block.
Q: What is the recommended torque for the studs to be installed into the ignition coil and the bracket?