FAQ for Door Hinge Repair
Q: What should be noticed while installing the rear side access door hinge?
A:
You shall maintain a wall thickness of 2 mm around the hole at end of the extension.
By BobGM Specialist
01/11/2022 Q: How to install the anti-chucking spacer block?
A:
The proper way is to make sure the door sill is clean and dry, lay the spacer block on the front side door frame sill approximately 325 mm (12.75 in) forward of the door latch mounting wall, and fasten the spacer block to the sill using self-tapping screws provided in the kit.
By BobGM Specialist
01/11/2022 Q: How to remove the door hinge roller pin?
A:
You shall remove the door hinge spring, the C-clips that retain the door hinge roller pins, the door hinge roller pins from the vehicle, and the old bushings.
By BobGM Specialist
01/11/2022 Q: How to install backing plates and reinforce service hinges (pillar cracked)?
A:
The proper way is to remove the factory hinge welds, lightly tap the pins to secure the pins in the hinge with the hammer, and apply a small amount of LOCTITE(TM) or equivalent to the head of the pins.
By BobGM Specialist
01/11/2022 Q: How to install the door hinge roller pin?
A:
The proper way is to install the new bushings, position the door on the hinges, and install the door hinge roller pins, the C-clips, and the door hinge spring.
By BobGM Specialist
01/11/2022 Q: How to remove the rear side door hinge?
A:
You shall remove the door from the body, the excess sealer surrounding the hinge and the lock-pillar trim panel, center punch each of the weld marks on the original hinge, and drive a chisel between the hinge and the door pillar.
By BobGM Specialist
01/11/2022 Q: What should be noticed while installing the anti-chucking spacer block?
A:
The spacer block must be positioned board of the door frame's outer surface.
By BobGM Specialist
01/11/2022 Q: How to install the rear side door hinge?
A:
The proper way is to position the bolt-on service replacement hinges within the scribe marks, center punch each bolt-hole location on the body hinge pillar and/or on the door, and install the hinges, the backing plate, the door, and the lock-pillar trim panel.
By BobGM Specialist
01/11/2022 Q: How to replace the door hinge?
A:
You shall use a spot weld drill of 1/2° rota broach bit to remove the factory hinge welds, lightly tap the pins to secure the pins in the hinge, and apply a small amount of LOCTITE(TM) or equivalent to the head of the pins.
By BobGM Specialist
01/11/2022 Q: What should be learned about while removing the rear side access door hinge?
A:
Original punch marks may not indicate the center of welds. You shall drill through the hinge only.
By BobGM Specialist
01/11/2022 See more FAQs (23)