< Back ×
My Vehicle Change Vehicle
2000 Chevrolet Blazer
< Back to View All
Light Relays, Switches & Control Modules
- Department
- Brands
- Prices
Cardone Reman® Remanufactured Body Control Computer for 2000 Chevrolet Blazer
PartNumber: 73-6801FProduct Specifications- Notes: RPO Configuration/Set-Up And Theft Relearn Is Required After Installation;with BCM Code 7125;Units must be flashed ON the vehicle.Vehicle specific on-car programming must be performed AFTER install to prevent drivability issues
- Connector/Terminal Configuration: Pin/Male; Pin/Male; Pin/Male
- Module Housing Material: Plastic
- Product Condition: Remanufactured
- Removable PROM: No
- Terminal Quantity: 24; 24; 16
- Part Description: 2000 Chevrolet Blazer Remanufactured Body Control Computer
Vehicle Fitment- 2000 Chevrolet Blazer | All Trims | All Engines
$84.69Cardone Reman® Remanufactured Body Control Computer for 2000 Chevrolet Blazer
PartNumber: 73-2445FProduct Specifications- Notes: with BCM Code 6430;RPO Configuration/Set-Up And Theft Relearn Is Required After Installation;Units must be flashed ON the vehicle.Vehicle specific on-car programming must be performed AFTER install to prevent drivability issues
- Connector/Terminal Configuration: Pin/Male; Pin/Male; Pin/Male
- Module Housing Material: Plastic
- Product Condition: Remanufactured
- Removable PROM: No
- Terminal Quantity: 24; 24; 16
- Part Description: 2000 Chevrolet Blazer Remanufactured Body Control Computer
Vehicle Fitment- 2000 Chevrolet Blazer | All Trims | All Engines
$85.83
FAQ for Body Control Module Repair
Q: How long should we turn off the ignition?
A:
You need to turn the ignition OFF for 10 seconds.
By Bob
GM Specialist
01/11/2022Q: How to remove the Body Control Module?
A:
You need to remove the left instrument panel sound insulator and the lower instrument panel sound insulator. Then you need to disconnect the electrical connectors from the body control module. Finally, you can bend the 2 snap retainers back slightly and pull the body control module from the bracket at an angle.
By Bob
GM Specialist
01/11/2022Q: What conditions may occur if the Programming Theft Deterrent System Components in the Theft Deterrent procedure are not performed after a BCM replacement?
A:
The vehicle will not be protected against theft by the PASSLOCK system, or the engine will not crank or start.
By Bob
GM Specialist
01/11/2022Q: Do I need to reset personalization after the procedure is completed?
A:
Yes, you need to set the personalization again, because the personalization settings of the BCM are set to a default setting.
By Bob
GM Specialist
01/11/2022Q: What do we need to notice when connecting or disconnecting the connectors to the BCM?
A:
You need to notice that the ignition switch must be in the OFF position.
By Bob
GM Specialist
01/11/2022